BENRUBI IZZY PG-900, Instruction Manual

Page: 27 / 34

26
6. Remove the cut hair regularly from the cutting guide. If several hairs accumulate, remove the
cutting guide from the device and blow and/or shake to clean it from the hairs.
7. When you finish clipping, turn off the device by pressing the On/Off switch (12).
8. Remove the cutting guide and the full size trimmer.
9. Clean the cutting guide, the full size trimmer and the device before storing it (see "Cleaning
and care").
Tips for better results:
• When you are trimming for the first time, set the cutting guide to 12mm until you become
familiar with it.
• For very short cuts (stubble look), use the cutting guide 3mm (6).
• For best results, move the device against the direction of hair growth. Since all hair does not
grow in the same direction, you need to move the device in different directions (upward,
downward or across).
• Ensure that the flat part of the cutting guide is in full contact with the scalp to achieve a
consistent result.
• Make overlapping passes over the head to ensure that you cut all hair that needs to be cut.
• To achieve a good result on curly, sparse or long hair, use a comb to guide the hair towards
the device.
Clipping with full size trimmer (without cutting guide)
You can use the device without a cutting guide to clip hair very short to the skin (0.6mm)
or contour the neckline and the area round the ears.
CAUTION: Particular attention is needed when cutting without a cutting guide because
the full width trimmer attachment removes any hair it touches.
1. Before you start to contour the hairline around the ears, comb the hair ends over the ears.
2. Attach the full size trimmer (1) to the body of the device.
3. Turn on the device by pressing the On/Off switch (12).
4. Turn the device in such a way that only one end of the cutting head touches the hair ends
when shaping the contours around the ears. Cut only hair ends. The hairline should be close to
the ear.
5. To shape the neckline and the sidebums, turn the device and make downward strokes. Move
the device slowly and smoothly following the natural hairline.
6. When you finish clipping, turn off the device by pressing the On/Off switch (12).
7. Remove the full size trimmer.
8. Clean the full size trimmer and the device before storing it (see "Cleaning and care").
Facial trimming (beard, moustache, sideburns)
Preparing for hair clipping:
• Ensure that the device is fully charged before you start the trimming process.
• Comb the hair to be trimmed with a fine comb.