13
Positioning your projector
Adjusting the projected image
Adjusting the projection angle
If the projector is not placed on a flat surface or the
screen and the projector are not perpendicular to
each other, the projected image becomes trapezoidal.
You can screw the adjuster feet to fine-tune the
horizontal angle.
To retract the feet, screw the adjuster feet in a
reverse direction.
Fine-tuning the image clarity
Go to
INSTALLATION
>
Motor Focus
and use / to adjust the focus settings.
Correcting keystone
Keystoning refers to the situation where the projected image becomes a trapezoid due to angled
projection.
To automatically correct this, enable
Auto Keystone
in the
INSTALLATION
menu.
To manually correct this:
1. Go to
INSTALLATION
>
Keystone
.
2. Press / on the remote control.
3. After the
Keystone
correction page appears, press
to correct keystoning at the top of the image. Press
to correct keystoning at the bottom of the image.
When done, press
BACK
to save and exit.
Do not look into the lens while the light source is on. The strong light from the light source may cause damage to
your eyes.
Press
.
Press
.
