![background image](http://html1.mh-extra.com/html/benq/mu686/mu686_user-manual_2734750022.webp)
Operation
22
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with a quick-release
adjuster foot and 2 rear adjuster feet. These
adjusters change the image height and projection
angle.
To adjust the projection angle:
1.
Press the quick-release button and lift the
front of the projector. Once the image is
positioned as desired, release the quick-
release button to lock the foot in position.
2.
Screw the rear adjuster feet to fine-tune the
horizontal angle.
To retract the feet, screw the rear adjuster feet in a
reverse direction.
If the projector is not placed on a flat surface or the screen and the projector are not
perpendicular to each other, the projected image becomes trapezoidal. To correct this
situation, see
"Correcting keystone" on page 23
for details.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press
AUTO
on
the projector or remote control. Within 3 seconds, the built-in Intelligent Auto
Adjustment function will re-adjust the values of Frequency and Clock to provide the best
picture quality.
The current source information will be displayed in the corner of the screen for 3 seconds.
This function is only available when PC signal (analog RGB) is selected.
Fine-tuning the image size and clarity
2
1
2
Do not look into the lens while the
lamp is on. The strong light from the
lamp may cause damage to your eyes.
Be careful when you press the quick-
release button as it is close to the
exhaust vent where hot air comes
from.
1.
Adjust the projected image to the
size that you need using the zoom
ring.
2.
Sharpen the image by rotating the
focus ring.