Operation 33
6.
You have successfully assigned a new
password to the projector. Remember to
enter the new password next time the
projector is started.
7.
To leave the OSD menu, press
MENU/EXIT.
Disabling the password function
To disable password protection, go back to the
SYSTEM SETUP: Advanced
>
Security Settings > Change Security
menu after opening the OSD menu system.
The message
'INPUT PASSWORD'
displays. Enter the current password.
• If the password is correct, the OSD menu returns to the
Security Settings
page with
'Off'
shown in the row of
Power on lock
. You will not have to
enter the password next time you turn on the projector.
• If the password is incorrect, the password error message displays. You can
press
MENU/EXIT
to cancel the change or try another password.
Though the password function is disabled, you need to keep the old
password in hand should you ever need to re-activate the password
function by entering the old password.
Switching input signal
The projector can be connected to multiple devices at the same time. However, it can
only display one full screen at a time. When starting up, the projector automatically
searches for the available signals.
Be sure the
Quick Auto Search
function in the
SOURCE
menu is
On
(which is
the default of this projector) if you want the projector to automatically search for the
signals.
You can also manually cycle through the
available input signals.
1.
Press
SOURCE
on the projector or
remote control. A source selection bar
displays.
2.
Press / until your desired signal is
selected and press
MODE/ENTER
.
Once detected, the selected source
information will display on the screen for
seconds. If there is multiple equipment
connected to the projector, repeat steps 1-2
to search for another signal.
• The brightness level of the projected
image will change accordingly when
you switch between different input signals. Data (graphic) "PC"
presentations using mostly static images are generally brighter than
"Video" using mostly moving images (movies).
