![background image](http://html1.mh-extra.com/html/benq/mp722st/mp722st_user-manual_2734690023.webp)
Operation
23
Operation
Operation
Operation
Operation
Starting up the projector
Starting up the projector
Starting up the projector
Starting up the projector
1.
Plug the power cord into the projector and into a
power outlet. Turn on the power outlet switch
(where fitted). Check that the POWER indicator
POWER indicator
POWER indicator
POWER indicator
light
light
light
light on the projector lights orange after power has
been applied.
2.
Open the lens cover. If it is closed, it could become
deformed due to the heat produced by the
projection lamp.
3.
Press
Power
Power
Power
Power on the projector or remote
control to start the projector. As soon as the
lamp lights up, a "Power On Tone
Power On Tone
Power On Tone
Power On Tone" will be
heard. The POWER indicator light
POWER indicator light
POWER indicator light
POWER indicator light flashes
green and stays green when the projector is on.
The start up procedure takes about 30 seconds.
In the later stage of start up, a startup logo is
projected.
(If necessary) Rotate the focus ring to adjust the
image clearness.
To turn of the ring tone, see
"Turning off the
Power on/off ring tone" on page 39
for details.
4.
If the projector is activated for the first time,
select your OSD language following the on-
screen instructions.
5.
If you are prompted for a password, press the
arrow keys to enter a six-digit password. See
"Utilizing the password function" on page 26
for details.
6.
Switch all of the connected equipment on.
7.
The projector will start to search for input
signals. The current input signal being scanned
displays in the upper left corner of the screen.
If the projector doesn't detect a valid signal, the message “No Signal” will continue
displaying until an input signal is found.
You can also press SOURCE
SOURCE
SOURCE
SOURCE on the projector or remote control to select your desired
input signal. See
"Switching input signal" on page 29
for details.
If the frequency/resolution of the input signal exceeds the projector's operating range, you will
see the message “Out of Range”
displayed on a blank screen. Please change to an input
If the projector is still hot from
previous activity, it will run
the cooling fan for
approximately 90 seconds
before energizing the lamp.