![background image](http://html1.mh-extra.com/html/benq/mh750/mh750_user-manual_2734661025.webp)
Operation
25
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 1 front adjuster foot and 1 rear adjuster foot. These
adjusters change the image height and projection angle. To adjust the projector:
1.
Screw the front adjuster foot. Once the image
is positioned where you want it.
2.
Screw the rear adjuster foot to fine tune the
horizontal angle.
To retract the foot. Screw the front and rear
adjuster foot in a reverse direction.
If the projector is not placed on a flat surface or the
screen and the projector are not perpendicular to
each other, the projected image becomes
trapezoidal. To correct this situation, see
"Correcting 2D Keystone" on page 26
for details.
•
Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyes.
•
Be careful when you press the adjuster button as it is close to the exhaust vent where hot air
comes from.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press
AUTO
on
the projector or remote control. Within 3 seconds, the built-in Intelligent Auto
Adjustment function will re-adjust the values of Frequency and Clock to provide the best
picture quality.
The current source information will be displayed in the upper left corner of the screen for
3 seconds.
•
The screen will be blank while AUTO is functioning.
•
This function is only available when PC signal (analog RGB) is selected.
Fine-tuning the image size and clarity
1
2
1.
Adjust the projected image to the
size that you need using the ZOOM
ring.
2.
Sharpen the image by rotating the
FOCUS ring.