47
Menu operation
Projector ID
Setting
Sets the projector ID for this projector (between 01~99). When multiple adjacent
projectors are in operation at the same time, switching the projector ID codes
can prevent interference from other remote controls. After the Projector ID is
set, switch to the same ID for the remote control to control this projector. See
Projector & Remote control on page 8.
Set the ID
1. Press and hold
ID SET
until the ID setting indicator lights up.
2. Enter the ID for the remote control (between 01~99). The remote control
ID should be the same as the corresponding projector ID.
3. The ID is saved successfully when you see the ID setting indicator starts
flickering and then blackout.
Clear the ID
1. Press and hold
ID SET
until the ID setting indicator lights up.
2. Press
ALL
to clear current ID setting of the remote control.
• The ID is cleared successfully when you see the ID setting indicator starts
flickering and then blackout.
Factory Default
Returns all settings to the factory preset values.
The following settings will still remain:
Projector Position
,
3D Keystone
,
Auto Vertical
Keystone
,
12V Trigger
,
High Altitude Mode
,
Baud Rate
,
Corner Fit
,
Image Resizing
,
Warping
,
Light Source Information
,
Security Settings
,
Network Settings
,
Projector
ID Setting
.
Reset System
Returns all the settings on the
System
main menu to the factory default values.
The following settings will still remain:
Light Source Information
,
Security Settings
,
Projector ID Setting
.
