Operation
40
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
•
Language
in the
SYSTEM SETUP: Basic
menu sets your familiar language for
the OSD menus. Press
MODE/ENTER
to display language page. Use
/
/
/
and
MODE/ENTER
to select your language.
•
Menu Display Time
in the
SYSTEM SETUP: Basic
>
Menu Settings
menu
sets the length of time the OSD will remain active after your last key press. The
time length ranges from 5 to 30 seconds in 5-second increments. Use
/
to
select a suitable time frame.
•
Menu Position
in the
SYSTEM SETUP: Basic
>
Menu Settings
menu sets
the OSD position in five locations. Use
/
to select a preferred position.
•
Reminder Message
in the
SYSTEM SETUP: Basic
>
Menu Settings
menu
sets whether to display reminder messages on screen. Use
/
to select your
desired setting.
•
Splash Screen
in the
SYSTEM SETUP: Basic
menu sets a preferred logo
screen to be displayed during projector start-up. Use
/
to select a screen.
Select the Light Mode
• Using the remote control.
Press
LAMP MODE
and the light mode selection
bar
appears. Use
/
to select
Normal/Economic/
Dimming
.
• Using the OSD menu.
1.
Press
MENU/EXIT
and then press
/
until the
SYSTEM SETUP: Advanced
menu is selected.
2.
Press to select
Light Settings
and press
MODE/
ENTER
. The
Light Settings
page displays.
3.
Select
Light Mode
and press
/
to select Normal
/
Economic
/
Dimming.
The light brightness vary from the
different light mode, see the description list in table below.
If the Economic mode or Dimming mode is selected, the light output will be
reduced and result in darker projected pictures.
Light Mode
Description
Normal
Provides full light brightness
Economic
Lowers brightness to extend the light source life and
decreases the fan noise
Dimming
Lowers brightness to offer a longer light source life.
