BenQ 9H.JMH77.26E, Installation Manual

Page: 7 / 272

English
6
Terminals
MONITOR OUT
Connection to other display equipment for concurrent
playback display.
HDBaseT
Connect an Ethernet cable (Cat5/Cat6) from HDBaseT
transmitter with high-definition video (HD), RS232 con -
trol and LAN control.
HDMI 1
Connection to HDMI source.
LAN
For connection to RJ45 Cat5/Cat6 Ethernet cable to
control the projector through a network.
3D SYNC OUT
Connection to 3D IR sync signal transmitter.
VIDEO
Connection to a video source.
RS-232 IN
Standard 9-pin D-sub interface for connection to PC con-
trol system and projector maintenance.
PC 2 (R/Pr, G/Y, B/Pb, H, V)
Connection to RGB or YPbPr/YCbCr output signal with
BNC type input terminal.
AUDIO OUT (L/R)
Connection to a speaker or headset.
WIRED REMOTE IN
Connection to a speaker or headset.
12V TRIGGER
3.5mm mini earphone jack, employs 200mA display relay
to provide 12(+/-1.5)V output and short circuit protec
-
tion.
PC
15-pin VGA port for connection to RGB, component
HD source, or PC.
DVI-D
Connection to DVI source.
HDMI 2
Connection to HDMI source.
USB 1.5A
Support 5V/1.5A output.
3D SYNC IN
Connect 3D-sync in cable from a computer or an en-
abled device.
SERVICE
Maintenance exclusive port for authorized maintenance
personnel only.
RS-232 OUT
Connects to another projector (same model) for RS-232
control.
AUDIO IN (L/R)
Connection to an audio input source via an audio or
audio L/R cable.
AUDIO IN
Connection to an audio input source via an audio cable.
WIRED REMOTE OUT
Connection to another projector.
Caution:
Make sure the port is valid before inserting a wired remote controller. The remote controller may be damaged in
case of an invalid port, e.g. a wired remote controller is connected to trigger output. For more information about
upgrading firmware via Lan, please contact BenQ service.