Installing Instructions:
Chapter 2
Setting the Meter
2.1 Installing/Replacing the Batteries
Please remove the plastic tab under the battery before using. This meter uses a CR2032
battery. Do not use or install different types of battery. It will damage the meter.
1
• Slide to remove the
battery lid.
2
• Insert the battery with
the
positive (+) side up.
3
• Slide back the
battery lid.
Note:
Dispose the batteries according to your local environmental regulations.
2.2 Set the Date and Time
Press “S” button for over three seconds. You will hear one “beep” for entering the setting
mode, then follow the instruction below to set up.
Setting order:
Year/Month/Date/Hour/Minute
• Click “M” button to advance one unit.
• Click “S” button to enter next setting.
• The meter will turn off automatically after setting.
Note:
Adjust the correct time and date is important to help managing your health records.
2.3 Code the Meter
Each vial of CHOL or UA strip has a code strip to code your meter. Code your meter when
you first use it or open a new vial of strips. With the Auto Strip Recognition function, once
you code your meter, you do not have to switch the test mode with code card every time
you perform a test.
1
• Make sure the meter
is off.
• Then insert the code
strip into
the test port.
2
• The code number will show on
the screen.Make sure the
numbers on screen, code
strip,
and strip vial label
are the
same.
• Then remove the code strip.
7
8
+
CR2032
C
H
O
L7
1
4
2
Test Strip
7142
Operation
Storage &
Transportation
Storage &
Transportation
90%
10%
153-229 mg/dL
8.5-12.7 mmol/L
C1303190
2016/01
7142
CH
OL
7142
