BendPak SP-7XE, Installation And Operation Manual, Page: 42 / 68

SP-7XE/F Full-Rise Scissor Lift
42
P/N 5900010 — Rev. B — June 2022
Add the Ramp Extensions
The Ramp Extensions add length to the Platforms for use with Long Wheelbase Vehicles.
There are two Ramp Extensions of different lengths; the Short Ramp Extension (5601614) attaches at
the Safety Lock end of the Platform, and the Long Ramp Extension (5601615) attaches at the Cylinder
end of the Platform.
⚠
DANGER The maximum load capacity for the Ramp Extensions must
not
exceed 25% of the
Lift’s rated capacity (1,750 lbs. / 793 kg.). Overloading the Ramp Extensions can
result in damage to the Lift or the Vehicle, cause serious bodily injury or death, and
voids the warranty.
To add the Ramp Extensions :
1. Determine which Ramp Extension you want to start with first, then move to the corresponding end
of the Platform.
The Short Ramp Extension attaches to the Safety Lock end, the Long Ramp Extension attaches to
the Cylinder end of the Platform.
2. Slide the Ramp Extension into the slots near the end of the Platform, then secure on each side of
the Ramp Extension from underneath using a M8 Hex Head Bolt.
3. Repeat the same steps for the other Ramp Extension on the other end of other Platform.