BendPak RS7580H603, Installation And Operation Manual

Page: 26 / 48

26
Every 4000 hours.
Perform the 2000 Hours procedures and:
Replace the lubricating oil.
Check the minimum-pressure control valve.
Check all electrical connections.
Check main bolts, main nuts and connectors are
tight.
Check all maintenance panel clasps for proper
operation.
Check intake-control valve.
Check electrical motor for bearing end play
ATTENTION:
Ensure all parts are properly secured or tightened
after performing maintenance tasks. Ensure all tools,
rags or equipment is removed from internal areas of
compressor before closing panels and starting up.
DAILY OPERATION AND MAINTENANCE:
Before start up:
ATTENTION:
Don’t open oil drain ball valve until five
minutes after stopping compressor.
1. Open the oil drain valve slightly and drain off any
water from the bottom of the oil Tank. Drain fluid until
water stops flowing and only oil flows. (See Fig 12.3 )
2. The oil level must be above the upper red line after
the compressor is off has been stopped for thirty minutes
The oil level when the compressor is running must be
between the upper and lower red line indicated on the Oil
Level Site glass. (See Fig. 12.4 )
3. Fill with PowerCool Synthetic Air Compressor
Lubricant if necessary and inspect the O-Ring on the Oil
Fill Plug before tightening.
4. After starting up: Watch the pressure on the control
panel. Check operating temperature and the general
conditions inside compressor.
INTAKE FILTER INSPECTION/
REPLACEMENT PROCEDURE
1. Open Drive Belt Side (right) panel. (See Fig.12.5 )
2. Unscrew the wing nut counter clockwise to remove
cover.(See Fig. 12.6)
Fig. 12.3
Minimum Oil Level
when stopped
and cold
Minimum Oil Level
while running
Fig. 12.4
Fig. 12.5
Fig. 12.6