BendPak 5175152, Service Manual

Page: 32 / 40

2
9
8
4
3
5
1
7
10
6
11
12
ISOMETRIC VIEW
FOR REFERENCE ONLY
DO NOT SCALE
ITEM
NO
PART
NUMBER
DESCRIPTION QTY REV
1 5766438 HDSO-14 CROSSTUBE 1 A
2 5735027 CROSSTUBE SAFETY BLOCK 2 B
3 5755030 HDSO-14 LONG CROSSTUBE AIR SAFETY TROUGH 1 A
4 5755011 SMALL AIR SAFETY TROUGH 2 B
5 5735023 HD-14 SERIES TOP CROSS TUBE STRAP 1 D
6 5735039 HD/HDSO-14 BOTTOM CROSS TUBE STRAP 1 D
7 5620228 HDS/HDSO-14 CROSSTUBE END PLATE SUBWELDMENT #1 1 K
8 5620229 HDS/HDSO-14 CROSSTUBE END PLATE SUBWELDMENT #2 1 J
9 5620230 HDS/HDSO-14 CROSSTUBE END PLATE SUBWELDMENT #3 1 H
10 5620231 HDS/HDSO-14 CROSSTUBE END PLATE SUBWELDMENT #4 1 J
11 5760003 D4-12, HD-12/14 RAMP STOP 2 C
12 5735073 D4-12, HD-7/9, HDS/HDSO-14 CARRIAGE TIE BLOCK 2 C
NEXT ASSEMBLY
5216144
WHERE USED
HDSO-14 SERIES
REVISION
REV DESCRIPTION DATE EDITED BY ECO#
A PRODUCTION RELEASE, DERIVED FROM 5600284 04/29/2022 TM 01414
SHEET 1 OF 3
REV DWG. NO.
A
SIZE
TITLE:
NAME DATE
CHECKED
DRAWN
A
1645 LEMONWOOD DR.
SANTA PAULA, CA 93060
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS DRAWING IS
THE SOLE PROPERTY OF BENDPAK INC. ANY
REPRODUCTION IN PART OR AS A WHOLE WITHOUT
THE WRITTEN PERMISSION OF BENDPAK INC. IS
PROHIBITED.
TM
5601816
HDSO-14 CROSSTUBE
WELDMENT
04/29/2022
DO NOT SCALE DRAWING
1:20 SCALE:
THIRD ANGLE PROJECTION
DIMENSIONS ARE IN MM
TOLERANCES:
0. = ±1.5
0.0 = ±0.5
SURFACE FINISH 1.6 ISO Ra µm
FOR MACHINED SURFACES
UNLESS OTHERWISE SPECIFIED
REFER TO MODEL FOR ADDITIONAL INFORMATION 1.
BREAK AND DEBURR ALL SHARP EDGES 0.3mm 2.
REMOVE ALL WELD SPLATTER 3.
DIMENSIONS SHOWN ARE AFTER PAINTING 4.
PAINT GRAY (RAL-7024) 20% GLOSS 5.
NOTE: UNLESS OTHERWISE SPECIFIED.