BENDIXKing E Series Lawrence, Programming Manual

Page: 21 / 29

CLONING RADIO SETTINGS
A radio with a keyboard and LCD display can transfer its programmed
settings to another radio by using a cloning cable. Both units must be
of the same frequency band. For example, an EPH series VHF radio
can transfer settings to or from an LPH or LMH series radio. An EPV
series UHF radio can transfer settings to or from an LPV or EMV series
radio.
A radio cannot transfer Alphanumeric display settings, including channel
labels, group labels, and Channel 0 Group Three functions. Neither can
it transfer settings for optional boards such as UCOM, scrambling, etc.
The radio (with a keyboard and display) transferring its programmed
settings is referred to here as a Master unit. The radio receiving the
programmed settings is referred to here as a Clone unit.
1
.
2 .
3 .
4 .
5 .
6 .
8 .
9 .
Make sure that both units are
connected to a charged battery pack.
Attach the Master end of the cloning
cable into the side connector of the
Master radio. This is the cable end
with the push-button Master switch.
Turn on the Master radio.
LPH and LMH: skip steps 4 and 5.
Put the Master radio in programming
mode by holding down the Master
switch and pressing the [FCN] key
until the LCD displays - - - ID.
Enter the correct Password Code and
press the [ENT] key.
Press the [FCN] key repeatedly to
review the values in Channel 0. Make
any required changes at this time.
Attach the other end of the cloning
cable into the side connector or mic
connector of the radio to be cloned.
Turn on the clone radio.
Press the [*] key on the Master radio.
Thedisplay will flash
PROG,
signifying
that the radio is ready to download.
20 BENDIX/KING