BENDIX Wingman Fusion FLR-21, Service Data

Page: 15 / 20

15
2.5 TABLE OF BENDIX
®
WINGMAN
®
FUSION
™
DIAGNOSTIC TROUBLE CODES (DTCs)
NOTE: Bendix
™
FLR-10
™
radar sensors use a different set of DTCs – see SD-61-4962 .
For DTC(s), refer to Table 4A. [Alternately, see a table sorted by SPN (Suspect Parameter Number) and FMI (Failure
Mode Identifier) code combinations in Appendix M.]
In Table 4A, find the DTC(s) found in column one and determine the Service Action Code(s) to look up in Table 4B.
Table 4A: Diagnostic Trouble Codes (DTCs), Descriptions, and Service Action Codes
Go to the
Service Action
Code List in
Table 4B
(Pages 22-30)
DTC Description SPN FMI
1–2 Internal radar sensor error 886 12 A
3 Antenna is dirty or partially blocked 886 17 B
4 Battery voltage too low 886 4
C
5 Battery voltage too high 886 3
6–10 Internal radar sensor error 630 12 A
11 J1939 Error Frame limit reached: J1939 wiring error 639 19
Y
12
Radar detects intermittent loss of J1939 messages from vehicle
components
639 9
13–14 Not used #N/A #N/A Not Used
15 Internal radar sensor error 886 12 A
16 Antenna is dirty or partially blocked 886 1 B
17–18 Internal radar sensor error 630 12 A
19 Not used #N/A #N/A Not Used
20 Internal radar sensor error 630 12 A
21 Not used #N/A #N/A Not Used
22 Internal radar sensor error 886 14
A
23–27 Internal radar sensor error 886 12
28 Internal radar sensor error 1799 14
D
29 J1939 signal: Missing AEBS2 message 5681 14
30 J1939 signal: Missing CCVS1 message 527 14 D
31 J1939 signal: Missing CVW message 1760 14
D
32 J1939 signal: Missing EBC1 message 1243 14
33 J1939 signal: Missing EBC2 message 904 14
34 J1939 signal: Missing EBC5 message 2919 14
35 J1939 signal: Missing EEC1 message 190 14
36 J1939 signal: Missing EEC2 message 91 14
37 J1939 signal: Missing ERC1_DR message 520 9
38 J1939 signal: Missing ERC1_XR message 520 14
39 Not used #N/A #N/A Not Used
40 J1939 signal: Missing OEL message 2876 14 D
41 Not used #N/A #N/A Not Used
42 J1939 signal: Missing VDC2 message 1807 14 D
43 Not used #N/A #N/A Not Used
44 J1939 signal: Missing EBC3 message 1091 14 D
45 Not used #N/A #N/A Not Used
46 Radar sensor is misaligned 886 7 G
Note: The system will not report newly active J1939 Diagnostic Trouble Codes (DTCs) until the engine has been
running for 15 seconds. Do not attempt to diagnose J1939 DTCs without the engine running.
Call the Bendix Tech Team at 1-800-AIR-BRAKE (1-800-247-2725), option 2, for troubleshooting assistance.
Table 4A – DTC Code to Service Action Code (Pages 15 – 21)