14
Service
Action
Code
Recommended Service
Q
This Diagnostic Trouble Code (DTC) is not an indicator of a malfunctioning camera.
Do not
replace the camera.
Possible Causes:
• The camera is indicating that it is either not calibrated or an error has occurred.
Perform the following:
•
The ABS controller may be disconnected or configuration from the ABS controller may be sending
invalid information.
• Go to Section 3.0
, measure and see if the camera was mounted properly on the windshield. If an
improper mounting arrangement is discovered, follow the instructions included in this document
to remove the camera. The adhesive cannot be re-used, but order the approved bracket with
adhesive (Bendix
®
part number K109285) to install and re-mount the camera onto the windshield.
After addressing the possible causes, perform the following:
• Clear the camera’s DTCs using the procedure in Section 2.18
Clearing Diagnostic Trouble Codes.
If the error returns, call the Bendix Tech Team at 1-800-AIR-BRAKE (1-800-247-2725), option 2.
Representatives are available 8:00 a.m.-6:00 p.m. ET, Monday - Thursday, and 8:00 a.m.-5:00 p.m. on
Friday, to assist you.
V
This Diagnostic Trouble Code (DTC) is not an indicator of a malfunctioning camera.
Do not
replace the camera.
Possible Causes:
• The system using the camera has not found the signal(s) it is expecting from the private
communications link. This could be accompanied by other active DTCs from the same source.
Review the following Section:
• 2.16
Private Communications Network Test Procedure.
Perform the following:
• Check the expected source(s) of the signal to identify why the signals have invalid data. The
private communications link may be disconnected, have improper terminations, power fuse
disconnected or blown, or a change was made to the controller that was incorrect.
• Clear the camera’s DTCs using the procedure in Section 2.18
Clearing Diagnostic Trouble Codes.
If the error returns, call the Bendix Tech Team at 1-800-AIR-BRAKE (1-800-247-2725), option 2.
Representatives are available 8:00 a.m.-6:00 p.m. ET, Monday - Thursday, and 8:00 a.m.-5:00 p.m. on
Friday, to assist you.
Note: The system will not report newly active J1939 DTCs until the engine has been running for 15 seconds.
Do not attempt to diagnose J1939 DTCs without the engine running.
Call the Bendix Tech Team at 1-800-AIR-BRAKE (1-800-247-2725), option 2, for troubleshooting assistance.
Table 2 – Service Action Codes to Recommended Service (Pages 11-14)
