13
Service
Action
Code
Recommended Service
N
This Diagnostic Trouble Code (DTC) is not an indicator of a malfunctioning camera.
Do not
replace the camera.
Possible causes:
• The system using the camera has found J1939 signal(s) it is expecting, however the values
indicate that there is a malfunctioning component and/or wiring error.
• Some examples of components, cameras or switches that produce J1939 signals are: brake
pressure switches; steering angle sensors; lighting indicators (high/low beam lights, turn signals);
windshield wiper status; various engine torque signals; Bendix
®
Wingman
®
Fusion
™
Active Safety
System components; and wheel speed sensors.
Perform the following:
• Check the engine, cab/body controller, Bendix Wingman Fusion components, or ABS for DTCs
using the manufacturer's diagnostic procedures. The controller that broadcasts the error signal
must be investigated first; however, the origin of the signal could potentially be another source.
After addressing the possible causes, perform the following:
• Clear the camera’s DTCs using the procedure in Section 2.18
Clearing Diagnostic Trouble Codes.
If the error returns, see the Bendix Wingman Fusion System (SD-61-4963) Service Data Sheet for
more troubleshooting information, or call the Bendix Tech Team at 1-800-AIR-BRAKE
(1-800-247-2725), option 2. Representatives are available 8:00 a.m.-6:00 p.m. ET, Monday - Thursday,
and 8:00 a.m.-5:00 p.m. on Friday, to assist you.
P
This Diagnostic Trouble Code (DTC) is not an indicator of a malfunctioning camera.
Do not
replace the camera.
Possible causes:
• The Bendix
™
AutoVue
®
FLC-20
™
camera finds an expected J1939 source, but the signal's value is
out of the normal operating range.
Review the following Sections:
• 3.6
Camera Interchangeability.
• 2.13
Serial Data (J1939) Troubleshooting Procedure.
Perform the following:
• Check the engine, cab/body controller, or ABS for DTCs using the manufacturer's diagnostic
procedures. The controller that broadcasts the signal indicates that a camera or switch input is
producing a value that is out of the normal operating range.
• After addressing the possible causes, perform the following:
• Clear the camera’s DTCs using the procedure in Section 2.18
Clearing Diagnostic Trouble Codes.
If the error returns, call the Bendix Tech Team at 1-800-AIR-BRAKE (1-800-247-2725), option 2.
Representatives are available 8:00 a.m.-6:00 p.m. ET, Monday - Thursday, and 8:00 a.m.-5:00 p.m. on
Friday, to assist you.
Note: The system will not report newly active J1939 DTCs until the engine has been running for 15 seconds.
Do not attempt to diagnose J1939 DTCs without the engine running.
Call the Bendix Tech Team at 1-800-AIR-BRAKE (1-800-247-2725), option 2, for troubleshooting assistance.
Table 2 – Service Action Codes to Recommended Service (Pages 11-14)
