11
2.11 TABLE OF SERVICE ACTION CODES
Recommended service actions for the Diagnostic Trouble Code(s) [DTCs] found.
For Suspect Parameter Number (SPN)
and Failure Mode Identifier (FMI) code combinations, see Appendix B
.
Service
Action
Code
Recommended Service
A
This DTC is not an indicator of a malfunctioning camera.
Do not
replace the camera.
Possible Causes:
• Some error conditions may occur at extreme high or low temperatures. These DTCs must be
diagnosed with the ambient temperature above 32°F (0°C) and below 100°F (38°C).
Perform the following:
• Clear the camera’s DTCs using the procedure in Section 2.18
Clearing Diagnostic Trouble Codes.
If the error returns, call the Bendix Tech Team at 1-800-AIR-BRAKE (1-800-247-2725), option 2.
Representatives are available 8:00 a.m.-6:00 p.m. ET, Monday - Thursday, and 8:00 a.m.-5:00 p.m. on
Friday, to assist you.
B
This DTC is not an indicator of a malfunctioning camera.
Do not
replace the camera.
Possible Causes:
These DTCs result from incorrect ignition, battery supply voltage, or wiring harness issues as
measured at the camera.
Review the following Sections:
• 2.12
Troubleshooting Diagnostic Trouble Codes: Power Supply; Ignition Voltage Too Low; Ignition
Voltage Too High; Power Supply Tests.
• 2.17
Troubleshooting Wiring Harnesses.
Perform the following:
• Verify ignition supply voltage to the camera is between 9 to 32 Volts DC (VDC);
• Visually check for damaged or poorly crimped connectors;
• Visually check for damaged wiring; and
• Clear the camera’s DTCs using the procedure in Section 2.18
Clearing Diagnostic Trouble Codes.
If the error returns, call the Bendix Tech Team at 1-800-AIR-BRAKE (1-800-247-2725), option 2.
Representatives are available 8:00 a.m.-6:00 p.m. ET, Monday - Thursday, and 8:00 a.m.-5:00 p.m. on
Friday, to assist you.
C
This DTC is not an indicator of a malfunctioning camera.
Do not
replace the camera.
Possible Causes:
• These DTCs may arise from infrequent conditions that could occur normally.
Perform the following:
• Check for lens obstruction. Clean dirt, packed snow, or ice from the lens, if present.
See Appendix
A to take a test image with the camera to help check that the view is clear.
• Clear the camera’s DTCs using the procedure in Section 2.18
Clearing Diagnostic Trouble Codes
(DTCs).
If the error returns, call the Bendix Tech Team at 1-800-AIR-BRAKE (1-800-247-2725), option 2.
Representatives are available 8:00 a.m.-6:00 p.m. ET, Monday - Thursday, and 8:00 a.m.-5:00 p.m. on
Friday, to assist you.
Note: The system will not report newly active J1939 DTCs until the engine has been running for 15 seconds.
Do not attempt to diagnose J1939 DTCs without the engine running.
Call the Bendix Tech Team at 1-800-AIR-BRAKE (1-800-247-2725), option 2, for troubleshooting assistance.
Table 2 – Service Action Codes to Recommended Service (Pages 11-14)
