20
ELECTRONIC WEAR INDICATOR
REPLACEMENT
(Normally-Closed or Normally-Open Type) See page 10.
New wear indicators are normally installed whenever brake
pads are replaced. Please see Brake Pad Installation on
Page 18 for cautions and procedures. The wear indicator
is installed after the new brake pads are installed into the
brake, but before the retainer hardware.
Remove and retain the pad holder springs.
See page 6 for typical contents of wear indicator kits.
Installation: The longer branch of the wear indicator cable
(see arrow) must be installed in the outboard pad. Insert
the Wear Indicator Cables (101) into the pre-cut slot in the
pads. The wear indicators snap into place.
Outboard Pad
101
12/1
12/1
Long
Cable
1
FIGURE 36 - WEAR INDICATOR CABLE
5. Install the cable guide (105) onto
the pad retainer (11). The cable guide
(105) snaps into place when pressing
lightly onto the pad retainer (11).
5
105
4. Install the pad retainer (11), pad
retainer pin (44), washer (45) and
spring clip (26) with the wear indicator
cable (101) as shown.
4
44
11
45
26
101
2. Insert wear indicator sensors into
the pads.
3. Install the pad holder springs (12/2)
onto the pads (12/1) with the wear
indicator cable (101) as shown.
2
3
12/2
12/2
101
12/1
