Bender LINETRAXX VMD461, Manual

Page: 44 / 84

Menu
44 VMD461_D00314_01_M_XXEN/10.2018
Legend for Fig. 6.2:
Line 1: Data record number
Line 2: Alarm status and alarm text (e.g. undervoltage,
underfrequency,…)
= no alarm
= alarm, fault
Line 3: Minimum and maximum measured value after the occur-
rence of an alarm
Line 4: BMS-bus address and measuring channel of the device
sending the signal
6.3 Menu "3. Settings"
6.3.1 General: Password protection
Settings can be password protected (menu 4.4). If the password is enabled, all
settings can be displayed. When an attempt is made to change settings, the
password entry screen appears automatically:
Once a valid password has been entered, access will be granted to settings in
all menus until menu mode is exited. If you cannot remember your password,
contact the Bender Service.
6.3.2 Procedure
The values can be changed in the third level of the menu (column "twice ")
using .
There are two different ways to exit the settings menu:
 
Save and exit: " "
 
Exit without saving : "ESC"
Please enter
password:
0 0 0