Settings
Settings
iso685-D-P_D00170_00_M_XXDE/06.2016
56
10.1
2.4.2.3.1
TEST
The functional test of the digital output can be activated or deactivated. This only applies
to the manual test and not to the cyclic device self test:
10.1
2.4.2.4
Function 1
Refer to
.
10.1
2.4.2.5
Function 2
Refer to
.
10.1
2.4.2.6
Function 3
Refer to
.
10.1
2.4.3
Dig. input
Select the digital inputs of the EDS that you would like to configure:
Now make the settings for the digital inputs of the EDS selected before.
•on
The manual test changes the status of the dig-
ital output.
•off
The manual test does not change the status of
the digital output.
•Select all
All digital inputs are selected.
•No selection
No digital input is selected.
•Invert selection
The current selection is inverted.
•Dig. input 1 (BS 2/1)
A single digital input is selected.
•Dig. input 2 (BS 2/2)
10.1
2.4.3.1
Mode
The operating mode for the digital input can be set to the following values. For a descrip-
tion of the operating modes, refer to
. The following can be selected
:
10.1
2.4.3.2
t(on)
The response time t(on) after a switch-on signal can be set between 100 milliseconds and
300 seconds. For a description of the operating modes, refer to
.
10.1
2.4.3.3
t(off)
The response time t(off) after a switch-off signal can be set between 100 milliseconds and
300 seconds. For a description of the operating modes, refer to
.
10.1
2.4.3.4
Function
10.1
2.4.4
Device settings
•Active high
An event is carried out on the rising edge of the digital
input (low to high).
•Active low
An event is carried out on the falling edge of the digital
input (high to low).
•off
Digital input without function.
•TEST
Device self test.
•RESET
Reset of fault and alarm messages.
•Select all
All devices are selected.
•No selection
No device is selected.
•Invert selection
The current selection is inverted.
•BS bus 2 (1-12)
