Benchmark AMS4A040, Operation And Maintenance Manual

Page: 30 / 39

AMS4A040 PANEL USER MANUAL Rev H Nov 2006 Page 30 of 39
6.4 DIGITAL DISPLAY SETUP
The four digital displays can be set for address, baud rate, and brightness.
The button nearest the connector selects the parameter (address, baud rate,
brightness).
The center button increments the parameter up
The end button increments the parameter down.
After the parameter is set, press the parameter button again to store it.
The addresses should be set as follows:
Line Tension = 1
Line Speed = 2
Depth = 3
MMD = 4
Set Baud Rate to 9600
Set Brightness to 15
6.5 BACK PANEL CONNECTOR PINOUT
J1 A 12 - 24 VDC IN
J1 B 12 - 24 VDC GROUND
J2-2 ENCODER1 PWR FUSED ENCODER1 PWR FUSED
J2 3 ENCODER 1A ENCODER INPUT
J2-5 ENCODER2 PWR FUSED ENCODER2 PWR FUSED
J2 4 ENCODER 1B ENCODER INPUT
J2 6 ENCODER 2A ENCODER INPUT
J2 7 ENCODER 2B ENCODER INPUT
J2-8 LOAD PIN +15 LOAD PIN +15
J2-9 SHUNT CAL
J2-10 LOAD PIN
J2-11 MMD PWR (+15) FUSED MMD PWR (+15) FUSED
J2 12 MARK- IN WEAK MARK IN + (2 WIRES)
J2-13 STRONG MARK - STRONG MARK IN +
J2 14 ENCODER GROUND (DCM) ENCODER GROUND
J2 15 ENCODER 1A* ENCODER INPUT
J2 16 ENCODER 1B * ENCODER INPUT
J2 17 ENCODER GROUND (DCM) ENCODER GROUND
J2 18 ENCODER 2A* ENCODER INPUT
J2 19 ENCODER 2B * ENCODER INPUT
J2-20 LOAD PIN -15 LOAD PIN -15
J2-21 LOAD PIN GROUND (ACM)
J2-22 LOAD PIN SIGNAL -
J2-23 MMD POWER GROUND (DCM) MMD POWER COMMON
J2 24 MARK+ IN WEAK MARK IN- (2 WIRES)