17
25-TON LOG SPLITTER - OWNER'S MANUAL
Beam Bracket
1. Attach the Beam Lock Bracket to the Beam &
Cylinder with Hex Bolt, Flat Washer, Lock Washer
and Hex Nut in two places. Tighten securely using
19mm socket wrenches.
2. Attach the Pivot Bracket to the Beam & Cylinder
using the four bottom holes with Hex Bolt, Flat
Washer, Lock Washer and Hex Nut in four places.
Tighten securely using 19mm socket wrenches.
Beam To Reservoir
1. Rotate the Stand attached to the side of the
Tongue downwards into position by releasing the
pin and then securing the release pin.
2. Remove the Retaining Clip and Hitch Pin from
the assembled unit (as shown below). Slowly
back the assembled unit up to the Beam & Cyl-
inder. Align the Tongue Bracket of the assembled
unit to the Pivot Bracket of the Beam. Once the
brackets are aligned, install the Hitch Pin through
the brackets then install the Retaining Clip into
the Hitch Pin.