K&A Manufacturing • 800.298.4351 • www.benchbud.com
5 of 12
Step 4
Step 3
For proper alignment of pre-drilled
holes, first insert screws at the four
corners of the U-channel. Then,
install the remaining screws.
• Align the U-channel (Q) with the pre-
drilled pilot holes*.
• Make sure the end with the holes closest
the edge faces towards the left leg.
• Attach U-channel to worksurface with
washer head wood screws (E).
•
Do NOT fully tighten
until all screws are
installed.
A
E
D
*Hole placement may vary depending on table width.
F
G
F
G
Left Leg
Left Leg
Important:
Please be aware that 5/8” screws are
provided. If your worksurface is 5/8” or thinner, you
will need to supply your own hardware.
• After hex rods are installed, align
left motor
bracket
and corresponding mounting holes on l
eft
leg column
(X).
• Position lock washers (G) and
tighten motor
mounting bolts (F).
• Repeat to attach
right motor bracket
to
right leg
column
(Y).
F
G
M
E
Holes closest to end of
U-channel face left leg.
Left Motor
Left Leg
Q
Q