K&A Manufacturing • 800.298.4351 • www.benchbud.com
4 of 12
Step 1
• Place the
left leg column (X)
onto the
worksurface and align with predrilled pilot holes.
Make sure leg is in its lowest position.
• Insert the short hex rod (R) through the
left motor
assembly (V)
(insert starting at bracket side of the
motor).
• Slide hex rod into left leg drive input hole. Hex rod
should slide all the way into leg.
• If hex rod is not properly aligned with drive input,
slightly rotate the motor 1/6th or
1/3rd of a turn.
Lay the worksurface on a protected
surface with pilot holes facing up.
LEGS MUST BE IN LOWEST POSITION
BEFORE INSTALLING HEX RODS.
Hex Rod Wrench
(O) can also be used
to rotate hex rod
O
R
Motor Assembly (V)
Reference below
images for proper
positioning of each
motor.
Step 2
Faces F
ront
Faces Leg
• Place the
right leg column (Y)
onto the
worksurface and align with predrilled pilot holes.
Make sure leg is in its lowest position.
• Insert the short hex rod (R) through the
right
motor assembly (W)
(insert starting at bracket
side of the motor).
• Slide hex rod into left leg drive input hole. Hex rod
should slide all the way into leg.
• If hex rod is not properly aligned with drive input,
slightly rotate the motor 1/6th or
1/3rd of a turn.
FRONT EDGE
FRONT EDGE
Left Motor
V
Left Leg
X
Left Leg
X
Y
Right Leg
W
Right Motor
(ID#802136)
V
Left Motor
(ID#801064)
Hex Rod Wrench
(O) can also be used
to rotate hex rod
O