S.p.A.
FT 530- FT 533
4
IDENTIFICATION CHARACTERISTIC TECHNIQUES
F
OR THE ENGINE FEATURES SEE THE ENGINE INSTRUCTION BOOKLET DELIVERED WITH THE MACHINE
.
•
Fuel
:
unleaded petrol
•
Recoil Starter.
•
Dry Air filter .
•
Oil in the gearbox : AGIP Diesel SIGMA SAE 30 0,6 Lts.
•
Max. Speed of the machine : (FT530) Speed 3 km/hour
•
(FT533)
: 1° speed:2,5 km/h; 2° Speed :3,2s km/hr; 3° Speed: 4,0 km/hr
•
Safety electric stop on the andle-bar.
•
Guidance handlebars can be adjusted in many positions (vertical and side adjustment)
The identification details of the machine ( Code Number, Engine Number, Weight, Power), are listed in a little Number
Plate, as shown in Pict.
2
, ref.
A
- Pict. n°2 - - Pict. n°3 -
PACKING AND ASSEMBLING OF THE MACHINE
◊
Width: 118 cms.
◊
Depth': 66 cms.
◊
Height: 72 cms.
•
The MACHINE is delivered packed IN CARTON BOX..
•
After having removed the rotary mower from the box, fix the handle-bar to the support as shown in Pict.3 and
adjust it to a comfortable position, then block it through the lever" Á.."
•
Mount the side conveyer on the deck, as shown in Pict.4 , using the four bolts M8 included.
•
The machine is delivered with oil in the gear-box.
•
ATTENTION: THE NEW MACHINES ARE DELIVERED WITHOUT OIL IN THE ENGINE. Fill with Oil SAE30 the
engine, through the inlet Pict.1 Pos. 5, and check the correct level (using the liner in the oil cap).
•
After mounting the handle-bar, you should adjust the control-cables.
•
The motor- stop and driving levers must be adjusted with the running engine (as mentioned in the next chapter)
•
It is important to verify that the safety motor-stop lever, Pict.5 Pos. C, is properly working : when you release it, it
should immediately stop the engine, and the blade (within 7 seconds). The engine is working only when you press
the lever. You can adjust it, if necessary, through the screw Pos. D , Pict. 5.
•
In the version FT 530 you can adjust the Power drive lever, Pict. 5, Pos..A, considering that the correct adjustment
is when the machine starts to move, and the hand lever is around 30° from the vertical position. If necessary, you
can adjust it , through screw Pos. F.
