S.p.A.
FC 210 3VS
OPERATING AND REGULATING THE MACHINE
Before you start mowing, oil the cutting blade, then start the motor as follows:
•
The release of the wheels and bar clutches should be done with the engine running at low speed.
•
Engaging the transmission to the wheels and the cutting bar by means of the clutch lever must be carried out with the motor at
a middle r.p.m. and by slowly releasing the lever.
•
When starting to mow, position the accelerator lever at ¾ or at "MAX" to ensure adequate power (Pict. 6).
•
When mowing along a wall or the edge of a sidewalk, be careful to keep a safety distance so that the blade does not suffer
impact. If not, the cutting bar may undergo damage.
•
When moving forward or back with the mower running, first squeeze the clutch lever which will block the bar, then squeeze the
wheel release lever and move as needed.
•
The handles can be adjusted in height and sideways (Pict. 9 Ref. “A”) by a multi-toothed device.
•
You can adjust the cutting height of the grass by the skids on the cutter bar (see instructions on the bars)
•
To regulate the motor, read the manual on the motor under "REGULATIONS".
•
ATTENTION:
DO NOT LEAVE THE MACHINE RUNNING WHEN NOT IN OPERATION
IMPORTANT: Working whit the machine for a longer time you should use ear
protection system.
MAINTENANCE
•
For changing the oil and other maintenance operations on the motor (spark plugs, air filter, regulations), refer to the motor
manual provided.
•
Make a regular check of the oil level in the gearbox with the cap (Pict. 10 Ref. "B") and topping up if necessary.
•
Change the oil completely every 200 hours. Empty the gearbox of oil by unscrewing the oil drain plug (Pict. 10 Ref. "C")
•
Allow oil to flow out completely. Then, unscrew the plug completely, and fill with new oil of the recommended type, unscrewing
breather plug (Pict. 10 Ref. “A”), up to the correct level - see the screw (Pict. 10 Ref. “B”).
•
If the grass is not cut in a satisfactory manner despite the adjustments, the blade must be sharpened or replaced. Follow the
instructions on the E.S.M. maintenance sheet.
•
For any mechanical repair, especially during the warranty period, we recommend to go to a specialised repair shop of the
dealer.
•
For transporting convenience, the handles can be disassembled by means of the two knobs (Pict. 9 Ref. "A"). The same is
recommended for the cutting bar, which is easily disassembled by after moving the locking knob (see Pict. 5). Always use
gloves and apply the protective strip to the blade.
•
Regularly check that screws are tight. Pay special attention to the screws fastening the bar to its support.
•
In the types with air filter in oil bath check the oil and clean the filter box every 10 working hours (see Pict. 11).
C
AUTION
It is advised not to keep the motor running when the machine is not being used for its
specific purpose
24
