BEMIS bioBidet UB-4800, Owner'S Manual

Page: 8 / 17

14 15
PRODUCT INFORMATION
This appliance is equipped with an
occupied sensor. The unit will not work
unless the seat is occupied.
SPECIFICATIONS
Recommended water supply pressure are 0.1~0.69MPa. The minimum available
water supply pressure is 0.07MPa, however under 0.1MPa pressure, water spray
pressure might not be adequate.
Item UB-4800
Standard power supply AC 120V 60Hz660W
Water supply Way of connection Direct connection to tap water
Water pressure 0.07MPa ~ 0.74MPa
Cleansing Spray for cleansing 900 +/- 100 ml/min
Spray for bidet 850 +/- 150 ml/min
Water capacity 800 ml
Spray temperature Room Temp ~ 104°F (40°C)
Heater capacity 600W +/- 10%
Safety feature Thermal switch, Temperature fuse, Floating
switch
Heated seat Seat temperature Room temp ~ 104°F (40°C)
Heater capacity 55W +/- 15%
Safety feature Temperature fuse
Circuit breaker Within 15mA 0.03 seconds
Length of power cord 1.2m
Dimensions (W) 407 mm X (L) 532mm X (H) 170mm
(W) 16.02 in X (L) 20.94 in (H) 6.69 in
Weight 4.16kg (9.17lbs)
INSTALLATION
1
3
3
2
2
4
5
6
1
6 5 4
Mounting Plate
Cone packing Washer Nut
Mounting bolt Guide
1. Remove the seat from
the existing toilet body.
•
Remove the nuts,
washers, and cone packings
from the toilet seat and
mounting bolts.
•
Then remove the toilet
seat, lid, and mouning bolts.
Keep them in case you
need them later.
2. Mount the plate
•
Place the mounting plate
and guides over each
mounting hole.
• Insert the mounting bolts
through the plate and
mounting holes.
•
Slide the cone packings and
washers onto the bolts and
fasten with nuts.