Details of Programming Options
12
13
Signal Strength Meter
MeterSTD
(Standard meter)
The meter displays the band, and bar graph
showing signal strength. (factory default)
MeterTHT
(Threat Display
™
)
The meter simultaneously tracks multiple
radar signals and provides the relative signal
strength for each signal received.
MeterTEC
(TechDisplay)
The meter displays the actual numeric
frequency of the radar signal being received.
Note: See more details on page 8.
AutoMute
aMute ON
(AutoMute on)
In this setting, the RX75 PLUS’s audio alerts
will initially be at the volume you set, but
after a few seconds, the RX75 PLUS will
automatically reduce the volume level, to
keep you informed, but not annoyed.
(factory default)
aMuteOFF
(AutoMute off)
With AutoMute off, the RX75 PLUS’s audio
alerts will remain at the volume you set for
the duration of the radar encounter.
Voice Alerts
VoiceON
(Voice announcements on)
In this setting, all radar and laser alerts,
including SWS messages, will be announced
in a digital voice, followed by the normal
tone. (factory default)
VoiceOff
(Voice announcements off)
In this setting, the standard tones will be
used.
City Mode Sensitivity
City STD
(Standard)
In this setting, when you put the RX75
PLUS in the City mode, X-band sensitivity is
significantly reduced, to minimize
annoyance from X-band intrusion alarms
and motion sensors. (factory default)
City LoX
(Low X-band sensitivity)
In this setting, when you put the RX75
PLUS in the City mode, X-band sensitivity is
reduced more than the standard setting.
This will reduce X-band alarms from other
sources even further, but also significantly
reduces range to X-band traffic radar.
City NoX
(No X-band sensitivity)
In this setting, when you put the RX75
PLUS in the City mode, the RX75 PLUS will
not respond to any X-band signals.
WARNING: Only choose this setting if
you are absolutely certain that there
are no X-band traffic radar units
where you drive.
Note: These settings only apply when the
RX75 PLUS is operated in City mode. X-
band sensitivity is not affected when used
in “Auto” or “Highway” modes.
Brightness
Brt AUTO
(Auto)
Display brightness automatically adjusted to
suit the ambient lighting in your vehicle.
Brt MIN
(Minimum)
Sets display to minimum brightness.
Brt MED
(Medium)
Sets display to medium brightness.
Brt MAX
(Maximum)
Sets display to maximum brightness.
Brt DARK
(Dark)
In this setting, the RX75 PLUS will only
display a very dim HD, AD, or CD for the
power-on indication, and will not show any
visual alerts when signals are detected.
Bands
BandsALL
In this setting, all radar, laser, and SWS
frequencies are monitored. This is the
factory default setting, and it is highly
recommended that you use your RX75
PLUS in this mode.
BandsMOD
In this setting, the RX75 PLUS will warn you
with an audible alert and a text message,
that one or more bands have been turned
off in programming (i.e. “SWS OFF”). This
warning is displayed during the start-up
sequence (standard or fast).
WARNING: Do not disable a radar or
laser band unless you are certain it is
not used for speed measurement in
your area.
Details of Programming Options
