Beltone myPAL Pro, Instructions For Use Manual

Page: 7 / 27

12 13
Turning your myPAL Pro ON and OFF
To turn the myPAL Pro ON, press and hold the Power button (see
page 8) for approximately 1.5 seconds, until the status LED turns
green. After releasing the Power button, the status LED will blink
green every 2 seconds.
To turn the myPAL Pro OFF, press and hold the ON/ OFF button
for approximately 1.5 seconds, until the status LED turns red –
indicating that the unit is shutting down.
If the battery level is low, the status LED will blink orange once
every second.
Pairing to your hearing instruments
i
Note! The following information is primarily intended for your hear-
ing care professional, who in most cases will complete the nec-
essary tasks needed before the myPAL Pro can be used with
your hearing instruments. However, the process is designed to be
simple and most people can do it themselves.
It is possible to pair up to three Beltone streaming devices - e.g.
one myPAL Pro and two TV Link 2s (optional Direct™ accessory)
- with a given pair of hearing instruments. Therefore, channel 1, 2
or 3 must be selected when starting the pairing process.
Pairing the myPAL Pro in channel 1
1. Make sure the myPAL Pro is turned ON. Your hearing instru-
ments must be OFF – open the battery doors.
2. With the tip of a pen
or similar object, press
the small pairing but-
ton once, as shown in
the picture to the right.
The status LED will now
blink orange once every
2 seconds to indicate that
the myPAL Pro is ready
to be paired in channel 1.
Your myPAL Pro will remain in Pairing mode for 20 seconds.
3. While in Pairing mode, close the battery doors on both hear-
ing instruments and make sure they are ON. A successful
pairing will be indicated by an audible melody being played
in both hearing instruments and the status LED (see page 8)
will stay solid orange for 3 seconds. You are now ready to use
the myPAL Pro!