12
RE-FUELLING - Burning wood
Only add fuel to your stove when you have just glowing embers, and the flames have died
down, this is the most efficient way to refuel your stove.
1. Before refuelling fully open secondary air slider to allow extra oxygen into the chamber.
2. Open door gently to allow pressure to equalise.
3. Add two pieces of wood not more than 1.2 Kg in total
4. Close the door.
5. Once the flames from the logs are fully established the secondary air supply can be adjusted to the desired
se ng.
TO LIGHT YOUR STOVE - Solid Fuel
Note:
on cold days it maybe necessary to warm the flue using two firelighters.
1. Place firelighters and a few smaller pieces of dry wood (kindling) among a small quan ty of fuel in the
combus on chamber.
2. Fully slide open (to the le ) the secondary air slider above the stove door on right hand side. Slide fully
to the le the primary air slider below the door of stove. The stove’s air controls are now fully open. Light
firelighters and securely close door.
3. With the fire established, open the door, and fill the chamber with fuel (see weight table on page 5). Do
not overload. (Do not cover ter ary air ports, see diagram page 13). Reloading is approximately every 2 hours.
4. Close fire door, set primary air to 45% open and set secondary air to 40% open.
5. Adjust as necessary.
The stove is only suitable for intermi ent use only: do not run overnight or for long periods una ended.
Experience will determine the se ngs that produce best results. Use a flue thermostat to check the stove
is not overhea ng. Flue thermostats should be placed directly above collar of the stove on a non insulated
sec on of pipe. (efficient opera ng temperature range is between 100
°C
and 200
°C
) The stove will get very
hot during use and due care must therefore be exercised.
Please use the glove supplied when opera ng air controls and door.
Never allow children to operate or refuel the stove.
RE-FUELLING - Solid fuel
1. To re-fuel your stove.
2. Before refuelling, open secondary and primary air controls fully.
3. Open door gently to allow pressure to equalise, de-ash your stove with use of a poker. (not provided)
4. Add fuel to below ter ary airbar (see weight table on page 6) and close the door.
Leave the air controls open whilst fire is established. Set primary air to 45% open and set secondary air to 40%
open.