Belshaw Bros., Inc.
•
www.belshaw.com
•
Phone 206-322-5474
•
Fax 206-322-5425
8
MN-1557EN-0317
Type F-YRD
Disassembly and Cleaning 3
CAUTION
Do not at any time use force to operate the
Type F cutter.
CAUTION
Disconnect power cord before assembling,
adjusting or disassembling the Type F
cutter.
Disassembly
1.
Disconnect power cord.
2.
Loosen the crown bearing clamp to release
the crown bearing.
3.
Release and swing away the hopper holding
clamp.
4.
Remove the cylinder, plunger and hopper as
one unit by lifting and tilting forward,
allowing the plunger to slip away from the
actuator (trip) arm and the cylinder to come
free.
5.
Remove the plunger and metering tube from
the hopper and cylinder. Release the wing
nut holding the plunger and metering tube
together, and pull the plunger out of the tube.
Remove the piston seals from the upper and
lower pistons.
6.
Remove the cylinder from the hopper by
pulling, with even pressure, until free.
Remove the piston seal.
Cleaning
1.
Wash the plunger, cylinder and metering tube
in hot water with an approved cleaner. Rinse,
wipe dry, and dip in edible oil.
2.
Wash the hopper in hot water with an
approved cleaner; rinse and wipe dry.
3.
Wipe the cutter head with a soft cloth,
dampened with water and cleaner. Remove
the cleaner with a damp cloth.
CAUTION
Do not spray power head with water or
cleaning solution at any time.
4.
Reassemble by reversing the Disassembly
process.
NOTE
Clean the extruder as soon as possible after
use.
