Belshaw Adamatic Bakery Group
www.belshaw-adamatic.com
206-322-5474
Donut Robot Mark II TS
MN-1013EN
9
Figure 2-3. Lubricating the Drive Gears.
6.
Replace the back cover of the heater head.
Checking the Thermostat
If the quality of your product decreases, check
the accuracy of the thermostat. Heat some
shortening in the fryer, measure the temperature
of the shortening using a thermometer you know
to be accurate, and compare this reading to the
thermostat setting. It is important that you put
the thermometer in the top 1”/2.5 cm or so of
shortening, because this is where the donuts are
fried, and this is where the temperature should be
consistent. If you need to calibrate the
thermostat, consult the “Electrical Components”
section.
Taking Care of the Plunger,
Hopper, and Cylinder
The plunger, hopper, and cylinder of your Donut
Robot are precision instruments. If you take
good care of them, they will perform well for
years. Follow these guidelines:
Clean these parts only in the manner
explained in this manual.
Handle these parts with care. Avoid
dropping them on hard surfaces.
Do not force the machine if it becomes
jammed. To avoid damaging the
plunger, disassemble the machine and
remove any obstructions.
Summary of Contents for Donut Robot Mark II
Page 28: ......
