Belshaw Adamatic Bakery Group
www.belshaw-adamatic.com
206-322-5474
4
MN-1013EN
Donut Robot Mark II TS
Assembling the Cutter
Read this section only if you are preparing to
make cake donuts.
1. Set the cutter head assembly onto the swing
column. (See Figure 1-5.)
Figure 1-5. Mounting the Cutter Head
Assembly.
2. Mount the hopper by sliding the two
mounting studs on the hopper arch into the
notches on the bearing strut. Secure the
hopper with the thumbnuts. (See Figure 1-
6.)
Figure 1-6. Mounting the Hopper.
3. Install the plunger as follows:
a. Pull the plunger connecting rod up and
out of the way.
b. Put the narrow part of the plunger’s
center rod through the slot in the center
of the hopper arch.
c. Lower the plunger until the wider part at
the top of the center rod enters the round
opening in the hopper arch and the
plunger’s piston just enters the hopper
cylinder.
d. Lower the connecting rod and insert the
pin into the hole near the top of the
plunger center rod. (See Figure 1-7.)
Summary of Contents for Donut Robot Mark II
Page 28: ......
