3
B)
To leave the program mode
Press: 0
The green LED will turn off, and two shorts beeps are heard from the buzzer
(=OK).
When in program mode and no button are pressed within 15 sec, the unit will
leave the program mode automatically.
C)
To program telephone numbers/alarm input
1)
Enter program mode by pressing * 5 * (green LED will light up, and two
shorts beeps are heard from the buzzer)
2)
Press # (the green LED will start flashing)
3)
Enter the telephone number max 17 digits. Using * will give a 3sec pause.
End by using #.
4)
Set the alarm input that will activate the telephone number:
Press 1 when alarm input A should activate the alarm
Press 2 when alarm input B should activate the alarm
Press 3 when input A or B should activate the alarm
End by pressing #
5)
Press the memory position 1-14 to store the number/alarm input, end by
pressing # (the green LED will stop flashing, and to be continuously on)
6)
To program next number start from 2) above, alternatively ID speech
program (E2 below), Relay program (F2 below), or press 0 to leave the
program mode (green LED will turn off).
D)
To erase a content in a memory position
Same as C) above, however do not enter any telephone number.
Use any alarm input 1-3.
E)
Selection of ID speech
1)
Enter program mode by pressing: * 5 * (green LED will light up, and two
shorts beeps are heard from the buzzer)
2)
Press: * (green LED will start flashing)
3)
Press any digit 0-9 as ID (two short beeps will be heard as OK, and the green
LED will stop flashing to be continuously on). If no ID speech set ID=0
4)
Press 0 to leave the program mode, alternatively program Telephone
numbers/Alarm input (C2 above), or Alarm relay (F2 below).
