BellSouth MH9932, Installation Instructions & Owner'S Manual

Page: 45 / 64

45
Using the Remote Voice Instruction Code
1. Dial your telephone number.
2. Listen to or bypass the OGM in primary mailbox.
3. Enter your Remote Access Code. If the announcement does not stop,
enter the code again.
4. The system will request that you enter the instruction code or press "0" for help.
A. If you do not know the instruction code, press "0" immediately. The
system will announce the Group I instruction codes. Otherwise, if a
command is not received by the system within 10 seconds, it will signal
3 beeps and hang up.
Group I Instruction Codes
Press "2" to play messages.
While playing messages, press "1" to repeat or "3" to skip.
While playing messages, press "4" to stop.
Press "6" to leave a memo. (To leave a memo on individual mailbox,
press "1" for mailbox 1, press "2" for mailbox 2, press"3" for
mailbox 3, and press "4" for mailbox 4.)
Press "6" again to stop taking message.
Press "7" to play OGM, press "77" to change OGM,
press "7" again to stop.
B. After the last instruction code of Group I, the system will request that
you enter the instruction code number or press "0" for help.
C. Press "0" to access to Group II Instruction Voice Menu.
Group II Instruction Codes
Press "8" to answer OFF, press "8" again to answer ON.
While playing messages, press "9" to erase message.
Press "99" to erase all messages.
Press "*" to change mailbox.
D. Press the corresponding number of the instruction code you wish to
activate. You don't have to listen to the entire instruction voice help
menu before giving a command. You may enter the desired instruction
code number at any given time.
NOTE: Pressing "0" while the instruction voice help menu is being announced
will prompt the system to repeat Group I instruction voice help menu.
Answering System Operation