HANDSET
Getting Started
After the battery is installed, the handset LCD will display “PLS REGIST.” put the handset onto the
charge cradle and seat in the cradle for minimum of 6 seconds for master base to complete the
charge ID code exchange and handset registration process. Confirmation beep for notifies the
success of the registration. After registration I s complete the LCD display change to Idle mode
display” RING:HI, HS# , Date/Time, CH#” … etc.
If 3 error beeps is appear which means the charge and registration is not completed user may lift the
handset and put the handset back to cradle again unit the single beep confirmation tone is appear.
Warning label to be put on that handset. “The handset charge on the master base will be
automatically registered. Place the extra handset from the small charger base to the master base
charge cradle.” “Wait minimum o f 6 seconds before removing the handset.”
If a total empty battery is installed the first time, put the handset on to the cradle and charge for 12
hrs or until the battery low ICON is disappear, when battery low ICON is disappear the handset will
show lift the handset, until the user lift the handset, the display will show “PLS REGIST.” user will
follow the register process to complete the registration process.
Getting Started
Press
button to confirm that you have
a dial tone. If you do not get a dial tone, review
step 3 through 11. If you still do not have a
dial tone, refer to the Problem solving section.
With the back of the
HANDSET
facing up,
insert one side of the BELT CLIP HOOK into
the matching slot at the top side of the
HANDSET
. Press down on the opposite side
of the BELT CLIP until the other HOOK locks
into the slot on the side of the
HANDSET.
13. Set the date and time on the HANDSET
You are now ready to use you new
BellSouth Cordless Telephone
IMPORTANT
In order to utilize the Caller ID feature, you must
subscribe to Caller ID service from your local
telephone company.
talk
ANTENNA
