Answering System does not work, check the following:
1.
BASE UNIT
is plugged into a power source.
2. Reset the system by pressing and holding the
button for at least 3 seconds.
Release the button and the unit will
“
beep
”
.
Answering System does not answer calls, check the following:
1. ANSWER ON/OFF LED indicator is lit.
Answers calls only after 10 rings, check the following:
1. ANSWER ON/OFF LED indicator is lit.
2. Message Memory is not full.
Does not respond to remote commands, ensure the following:
1. Correct Remote Access Code is entered.
2. A TONE telephone is being used.
Message is incomplete, ensure the following:
1. Message Memory is not full.
2. Caller may be hesitating and pausing for more than 7 seconds.
Answer calls but does not record messages, check the following:
1. ANNC/ICM switch is set to ICM.
2. Memory is not full.
3. Extension telephone was not picked up.
Answering System announces Time is off
at the end of each message,
check the following:
1. Have you set the Day/Time?
2. Was there a power interruption?
No Sounds on the BASE UNIT:
1. Adjust the volume by using
and
button and make sure the volume level is not
“0”.
Reset your cordless telephone:
1. You can reset your unit if the unit is not working properly. Unplug and then plug the AC
ADAPTER into its power source, then press and hold down the
button for at least
3 seconds, then release the button and the unit will
“
beep
”
. (See detail operations in page
28.)
NOTE
: If none of telephones in the house are working, disconnect one set at a time to verify
that none of the phones are causing the problem. If you still have a problem after doing
this, and your telephone still does not work, please contact your local phone company.
stop
stop
41
Problem Solving
