Problem Solving Section
For your assistance, we have listed below a few common problems.
Phone does not work, check the following:
1.
BASE UNIT
is plugged into a power source.
2.
HANDSET
is charged.
3. TONE/PULSE Select switch is in the right position.
4. TELEPHONE LINE CORD is plugged into the TELEPHONE JACK.
Range of phone limited, check the following:
1.
BASE UNIT
is centrally located in your residence.
2.
BASE UNIT
is not located near appliances.
No dial tone, check the following:
1. TELEPHONE LINE CORD plugs are connected to the TELEPHONE JACK and
TELEPHONE LINE CONNECTION JACK.
2.
BASE UNIT
is plugged into a power source.
3. If you had a power failure or had unplugged the
BASE UNIT
, replace the
HANDSET
on the
BASE UNIT
for 2 to 5 seconds to reset the system.
Received signal flutters or fades, check the following:
1. BATTERY PACK in the
HANDSET
is fully charged.
2.
HANDSET
is not too far from the
BASE UNIT
.
Interference on reception, check the following:
1. Noise may be picked up from electrical products in the home or electrical storms. Generally,
this noise is a minor annoyance and should not be interpreted as a defect in your system.
(See Technical Information on page 42.)
2. Choose an alternate channel using the
button on the
HANDSET
.
3. Do not use this telephone within 20 ft. of a microwave oven while it is working, as you may
experience interference. This is a normal occurrence with 2.4 GHz phones and should not
be interpreted as a defect in the product.
Long Distance L-D-C
indicator is not ON when receiving a long
distance call, check the following:
1. Your local telephone company can provide the Area Code on an incoming long distance call.
Excess static, check the following:
1. Check to see that the ANTENNA is not touching another metal object.
If after pressing the
button, you receive three beeps
and no dial
tone, check the following:
1.
BASE UNIT
is plugged into a power source.
2. If you had a power failure or had unplugged the
BASE UNIT
, replace the
HANDSET
on the
BASE UNIT
for 2 to 5 seconds to reset the system.
tallk
delete
scan
40
Problem Solving
