Carry out all cutting of the unit and work surface then carefully remove shavings or sawdust
before inserting the appliances.
To ensure a correct ventilation of the hob please comply with the dimensions shows in figures.
Always refer to the manufacturer for specific instructions,
Make sure the surface is level and square and that no part interferes with the space required
for installation.
Prepare the cut as indicated (see installation dimensions).
Installing the hob
WARNING
Risk of cutting.
Be careful of cutting edges.
End parts in foamed plastic - be careful.
During transportation, these could cause slight injury or cuts.
Remove the material and envelope of documents from the packaging.
Before proceeding with installation read the work instructions carefully.
Step.1
Put a towel or cloth on the work surface. Place the hob face
down
on the protected surface.
Step.2
Apply the strip seal, supplied with the hob, which is for sealing it onto the
work surface.
Do not use silicone. Apply the seal to the edge of the bottom of the hob,
leaving about 3mm from the edge of the glass.
Apply the seal all around the circumference.
Cut any excess and bring the two ends of the seal together so they match.
Step.3
