Installation
Preparing the unit for a built-in appliance
1. Drill a hole on the table surface according to the size shown in the drawing. For the purpose
of the installation and use, a minimum of 50mm space shall be preserved around the hole.
Be sure the thickness of the table surface should be at least 30mm.please select heat-
resistant table material to avoid larger deformation caused by the heat radiation from the
cooker. As shown in the Figure 1.
2. ATTENTION: important assembly instructions for keeping the induction module cold.
3. Do not install the hob on top of a refrigerator or dishwasher. If the hob is installed on top of a
drawer put a shelf in between as shown (50mm).If shelves are put in between ensure that
they allow air to flow (30mm).
Product dimensions
WARNING
The kitchen units that are in direct contact with the appliances must be heatproof (min. 95°).
The appliance can be installed on a work surface with a thickness of between 30 and 40 mm
and near to walls, which are higher than the work surface, maintaining a minimum distance
of 100 mm.
