Installation
6
- To install your appliance above an oven
The Induction hob may be flush-mounted above an
oven of the same brand.
This oven has an upper ventilation system
and can therefore be installed in a elevated
position.
To do this, remove the front cross bar of the
cupboard and allow for a minimum space of 5 mm
between bench top and top of the oven to facilitate
adequate ventilation .
Important:
Your induction hob must NOT be installed
above a dishwasher, washing
machine, refrigerator or freezer
3. Preparation
Ensure that surface directly surrounding the cut –out in the bench top is free of grease and dust to provide
clean surface for adhesion of the seal .
4. Electrical connection.
Important:
If the supply cord is damaged in any way it must be replaced by the manufacturer, after sales service or by
authorized technical staff, to avoid hazard.
It must be connected to mains power supply via a socket outlet complying with EEC publication 7 and a
single-pole cut-off device with a contact opening distance of at least 3 mm.
If the mains power supply where the hob is to be installed is different from 220...240V~, make the
connection as shown in the enclosed diagrams.(The cable must be able to withstand temperatures of 120C).
Before doing this disconnect from the mains
supply. A good earth connection is necessary and a switch for
disconnecting all the phases must be placed accessibly, with a minimum distance of 3 mm between
contacts.
Step 1: Open terminal board cover at rear panel of appliance.
○
+
3(L3)
○
+
4(N2)
○
+
2(L2)
○
+
5(N1)
○
+
1(L1)
○
G
Ground
Summary of Contents for BI63T
Page 14: ...12 NOTES...
