Maintenance & Troubleshooting
10
Caution:
Before maintenance or cleaning is carried out, the range hood should be disconnected from the main power
supply. Ensure that the range hood is switched off at the wall socket and the plug removed.
Spills and splashes will not harden and stick to the glass, as it hardly heats up.
Both Vitro-ceramic and induction rings should however be cleaned of any spills or splashes as quickly as
possible.
Slight stains can be removed with kitchen paper or cloth.
More resistant stains will need specific product for vitro-ceramic glass. Follow each product’s inductions.
Important:
Do not use abrasive products or cleaning powders as these could scratch the hob.
Do not use a steam cleaner.
If any cracks should appear on the surface of the glass, unplug he appliance immediately.
Do not use any part of the hob until a new vitro-ceramic glass has been installed.
Problem
Possible causes
What shall I do
The induction hob is not
working. The pilot lights on
the keypad are all off
There is no electrical supply to
the appliance. The supply or
connection is defective.
Check the state of the electrical installation.
Check the fuses and differential switches.
The differential switches of
your installation are triggered
when the hob is switched on.
The hob connection is defective
Check the connection is OK.
The induction hob switches
off during use. The message
“C” appears.
The electronic circuits have
heated up.
Check the conformity of your installation,
particularly the air inlets and outlets, as
indicated in the instructions.
The induction hob switches
off during use. An intermittent
beep sounds.
A pan has boiled over onto the
controls.
Press any button. The beeping will stop.
Clean the controls and continue cooking.
The pilot lights on the keypad
continue to flash when the
hob is functioning.
The pan being use is not suitable
for induction cooking.
Use a compatible pan. pans can be tested
with the magnet.
The hob continues to
ventilate for several minutes
after switching off.
The electronic circuits are cooling
down.
This is normal.
The hob is not working and a
different message appears.
The electronic circuit is not
working correctly.
Contact the after-sales service.
Summary of Contents for BI63T
Page 14: ...12 NOTES...
