Bellini BGT64XP, Installation & Operation Instructions

Page: 6 / 18

4
AS/NZS 3000
– Electrical Installations (Wiring Rules)
Building codes
Any other relevant statutory regulations.

Check the gas type label on the underside of the hotplate, adjacent to the gas connection
to ensure it corresponds to the installation gas supply. If in doubt, contact the supply
authority.

The power supply cord (supplied) must not touch against any hot surfaces and must be
placed so that its temperature does not exceed 75 degrees at any point along its length.

After connecting to gas, check for leaks using soapy solution, never a naked flame.

Where a flexible hose assembly is used, ensure it is approved to AS/NZS 1869, Class B
10mm diameter and no more than 1.0metre in length. Any hose assembly used must be
restrained from accidental contact with the flue outlet of an under bench oven.
How to Avoid Damage to the Appliance

Do not use the cooking zones with empty cookware or without cookware.

The ventilation gap of 5mm between the worktop and front of the unit underneath it must
not be covered.

DO NOT MODIFY THIS APPLIANCE.
Safety When Cleaning

For cleaning, the appliance must be switched off and cooled down.

For safety reasons, the cleaning of the appliance with steam, jet or high-pressure
cleaning equipment is not permitted.
Disposing Of the Device
When disposing of the device, do not bring it to regular municipal waste containers.
Instead, bring it to electrical and electronic waste recycling and reuse center. A
relevant label has been put on the device, its instructions manual, or the package.
The device has been manufactured of recyclable material. By bringing old device to recycling
collection center, you show that you care about nature. Ask your local environmental care
authority for information on location of such facilities.