INSTALLATION
Fitting into worktop
Cut a hole in the work surface to the
required size. The worktop must be of
heat-resistant material or covered with
heat-resistant material.
Protecting the cut-out;
The types of chipboard used for work
surfaces swell relatively quickly in contact
with humidity.
Apply a suitable sealant to the cut edge to
protect it from moisture ingress.
This hob can be installed conventionally
(glass above the work top) or recessed
into the work top for a fl ush fi t.
Self adhesive seal
Apply the self adhesive seal to the
underside edges of the hob glass. For best
results, the seal should be adhered along
each side in turn, as close to the edge as
possible, and trimmed at each corner, tak-
ing care to ensure a neat join.
SEAL
UNDERSIDE OF HOB
Conventional Installation
Refer to the installation bracket advice
to determine your installation type. Place
the hob in the aperture, checking the hob
glass is covering the work top along all
four sides.
Set the front edge of the appliance paral-
lel with the front of the work top.
Locate and attach the securing clamps
as required, Tighten the screws so that
the hob is pulled down fi rmly against the
worktop, thus ensuring a good seal.
Recessed Method
Recess the work top to the appropriate
depth (Approx 5mm) and shape to fi t the
hob (add 1mm to overall glass size). Refer
to the installation bracket advice to deter-
mine your installation type. Insert the hob
into the recess, ensuring that the foam
seal is sitting correctly. Locate and attach
the securing clamps as required, Tighten
the screws so that the hob is pulled down
fi rmly against the worktop, thus ensuring
a good seal.You may want to fi ll any gap
between the hob top glass and the work
top surface with silicone sealant.
DO NOT fi t silicone sealant under the
glass hob instead of the self adhesive seal.
1
SELF ADHESIVE SEAL
Worktop
Hob
CONVENTIONAL INSTALLATION
1
Worktop
Hob
RECESSED METHOD
2
1
2
1
SELF ADHESIVE SEAL
SILICONE SEALANT
