23
INSTALLATION
Installing your new cooker
Safety warnings about installation
• The cooker must be installed and serviced only by an authorized person.
• A certificate of compliance must be supplied by Installer and is to be kept by the customer.
• The packing materials must be removed before you install the cooker.
• You must follow the installation instructions in this booklet.
• The surrounding kitchen cabinets must be able to withstand 85°C. We will not accept
responsibility for damage caused by installation in to kitchen cabinets which cannot withstand
85°C.
• The appliance must not be installed in a corner. It must be installed at least 100mm from the
side wall.
• The vents; openings and air spaces must not be blocked.
• The anti-tilt plate must be installed to avoid accidental tipping.
• The stabilizing bolt must be installed to avoid accidental moving.
• You must not pull the cooker by the door handles.
• Power socket, if provided for gas models, and electricity isolation switch for electric models
and gas models without a 20A plug, is to be installed in an accessible position near the
cooker (but not behind cooker).
• If the supply cord or cable is damaged, it must be replaced by an approved service agent or
a similarly qualified person in order to avoid a hazard.
Note: Only service centers should carry out servicing. Otherwise warranty may be void.
Installing cooker - power connections
Fitting on a Power Supply Cable
Connecting appropriate power supply ` terminal board/ connector block:
• Using a screwdriver ,prize open tabs of the Terminal board cover.
• Remove the wire clamp screw.
• Fasten the wires beneath the corresponding screw heads, using brass ‘bridge’ for single
phase supply.
• Fasten cable clamp and close the cover of the terminal board.
• The ac power supply should be 220-240 V, 50/60 Hz. For electric cookers, the minimum
45A fuse, or at least 45A a distribution circuit breaker. For gas cookers, the minimum 20A
fuse, or at least 20A circuit breaker.The appliance has been designed to fit in a 550mm wide
gap in kitchen cabinets. The cooker may also be installed at the end of a line of benches or
with a free space on either side.
