14
Bell
fi res
English
Instructions for use & Installation instructions
1.7.10
MAN mode for manual fl ame height adjustment
•
Press to turn on the fi re (main burner) or to increase fl ame height.
• Press to decrease fl ame height or to turn down the main burner. The pilot
stays on.
• To incrementally increase or decrease the fl ame height lightly tap either the
or button.
• The
SEND
symbol appears in the upper left corner of the display when either
button or is depressed.
• The
LED
of the receiver fl ashes if you reach the end stops of the valve.
1.7.11 Automatic mode for temperature control
• Briefl y press
AUTO
. The set temperature will appear briefl y before the display
reverts to the room temperature.
1.7.12 TIMER mode (TIMER in display)
• During heating periods
P1 and P2, the temperature is controlled in the same manner
as in
AUTO
mode.
• When the timer program turns to (heating cycle off), the motor will turn the valve
to pilot and there is no temperature control. This minimizes battery consumption.
• You may press
AUTO
to verify the set-temperature and then press
TIMER
to
return to timer mode.
• Press either the or button from any mode for manual override.
• For the
AUTO
or
TIMER
mode to function correctly, the transmitter must remain with
range of the receiver.
1.7.13 Changing the battery
• If
BATT
appears in upper right corner of the display or if the
LED
of the receiver
becomes faint, please change the battery from transmitter or receiver.
See also 1.7.15
• If the batteries lose power, the fl ame height can be adjusted by manually turning
knob
B.
1.7.14 Extinguishing the pilot light
• The pilot light extinguishes by slightly pressing the spring loaded control knob
A
and
by turning it to the right to the “
OFF
” position (
l
-symbol).
• If the gas fi re is not going to be used for a long period of time, it is recommended to
close the gas supply valve to the fi re.
Important:
If the pilot light goes out for any reason,
wait for 5 minutes before attempting to
re-light it.
