Bellfires Smart Bell 70 PF, Installation Instructions & Manual For Maintenance, Page: 30 / 68

30
Bell
fi res
English
Installation instructions
6. Install the rigid concentric pipe system (if a fl exible pipe system is not being used)
A rigid concentric (Ø100-Ø150 mm) pipe can only be fi tted to the appliance if the
appliance is being installed in a newly built chimney.
Place the concentric pipe on top of the appliance. Depending on the chosen
concentric fl ue pipe system, the use of an adapter of that system, is sometimes
necessary. Make sure that all connections are completely gastight.
7. Gas and electricity connection:
Using a compression fi tting you can connect the gas to the appliance.
Beware that during connection there is no power supply to the gas regulating
block and pipes.
Prevent the power cord touches the side of the unit. This is due to the high
temperatures of the appliance. Keep this in mind when making the connection to
the wall socket.
8. Check for gas-tightness and appliance functioning:
After assembly check all gas (compression) connections for gas-tightness using
soapy water or a gas leak detector. Also leave the appliance to burn for a while
(maximum 1 minute !) before proceeding. Please consult the instructions for use,
supplied separately with the appliance.
9. Positioning the ceramic log set, ‘fi re glass’, embers and decorative ash
The appliance can be supplied with:
• Ceramic log set; See Log Nos. 14 to 25 below.
• ‘Fire glass Black’
• ‘Fire glass Dark Amber’
• Embers
• Decorative ash