44
Installation
4.1
Installation prerequisites
1. Make sure that the location agrees with the requirements. Refer to the preparation
manual.
2. Make sure that the details of the rating plate of the appliance agree with the gas type
and gas pressure of the gas supply.
4.2
Installation procedure
Note:
The appliance is factory set to the correct nominal heat input. The pilot light is
set to the correct level of gas consumption.
•
Do all the procedures in this section. Optional procedures are indicated with
(optional).
4.2.1
Install the appliance
Safety conditions
Caution:
Do not install the appliance against a flammable rear wall.
Procedure
1. Install the carrying brackets (A). Use
the fasteners (B). You can use the
carrying brackets to move the
appliance.
2. Install the appliance. Make sure that
the distance x is approximately 2 cm.
3. Remove the carrying brackets.
4. Put a nonflammable insulation plate
(B) of at least 12 mm thick between
the appliance and the rear wall.
Make sure that the insulation plate
covers the entire area of the rear of
the appliance.
Installation
18
Smart Bell 65-55
