10
Operating Instructions
GB
STOPPING
1.1 Depress RED Button
(or on/off toggle
switch if fi tted to the Off
position) to stop mixer
(Fig
B).
STARTING
1.2 Lift rear door.
1.3 Feed supply cable out
through the rear of the
mixer and plug into
power
supply.
1.4 Depress GREEN
Button (or on/off toggle
switch if fi tted to the On
position) to start mixer
(Fig
A).
-
Ensure supply cable is safely stored before moving mixer.
-
Keep rear door shut when mixer is running
EMERGENCY STOP
1.5 Depress large RED Button, situated on top left hand side of power unit housing (Fig C).
-
110V & 415V (Brook Hansen) motor, Start / Stop using a control box situated on inside left of power unit housing.
2. YANMAR (ELECTRIC START)
STOPPING
2.1 Press Red Lever (Fig D).
- Note:
Red indicator light
glows when engine charging
system
fails.
-
Ensure that when machine
is not in use that ignition is
switched OFF, or battery
failure may occur.
EMERGENCY STOP
2.2 Pull the handle on the
side of the power unit box to
STOP the machine (Fig E).
COLD STARTING
2.3 Lift rear door.
-
Open fuel cock if fi tted (Fig F).
2.4 In cold starting situations the engine requires 2cc of engine oil (10w-30) to be applied using oil applicator. The oil
should be inserted into the engine byremoving the rubber plug on thepriming port, ensure the plug isreplaced (Fig G).
2.5 Ensure the Emergency Stop Button is pushed in (Fig H).
2.6 Set the engine speed lever (situated on the left hand side of engine) to the run position (Fig I).
2.7 Turn ignition key clockwise untilengine turns over, release key whenengine starts. If engine fails to start, repeat process of cold start.
- Note:
Once an attempt to start the engine has failed, before re-trying the key must be turned back to the OFFposition.
-
DO NOT operate with rear door open.
WARM STARTING
2.8 Repeat process above from 2.5.
1.
ELECTRIC MOTOR : VARIANTS
A
B
C
D
PULL
TO
STOP
E
Open
Closed
F
